国产一级无码AV片在线看_中国国产高清一级毛片_YELLOW高清在线观看免费观看_亚洲欧美日韩色网_日韩美A一级毛片免费网站_成人精品人成网站_九九九av免费观看_国产精品午夜一级毛片密呀_欧美色区亚洲色第一页10p_亚洲精品成人av观看在线

Menu

News and Information

>Laster News>News and Information

Adjustment method for grinding head of glass bilateral machine

Publisher: YUANBO    Time:10/20/2021 4:11:14 PM


     1. Adjust the width and thickness of the glass; Turn on the grinding head motor and make sure to wait for 2 minutes of idle operation before attempting grinding

     2. Attention during trial grinding: Observe the operation of the entire machine, and if any abnormalities are found, stop the machine immediately (press the main stop button). Exit the glass and troubleshoot before starting the machine
High efficiency of glass bilateral machine
     3. Appearance, dimensions, and other matters can only be mass produced after the first piece is confirmed to be qualified

     4. When adjusting the coarse and fine grinding wheels, only 0.1mm of the grinding wheel can be fed and cannot be adjusted in place at once

     5. If the glass to be ground has entered the upper and lower clamping sections and there is any glass misalignment or fragmentation, it cannot be directly pulled by hand (Stop the machine and lift the upper conveyor belt to remove the glass or use a hammer to break both sides of the glass to avoid colliding with the machine.)

     6. At the end of each processing shift, first turn off the grinding head motor and then turn off the conveyor. When turning off the cooling water motor, clean and rinse the broken glass on the conveyor belt and its guide rail, feed rollers, and other components in a timely manner, and clean the water tank, water tank suction nozzle, to prevent the glass powder from settling and blocking the cooling water system for a long time. Use a dry cloth to wipe the surface of the machine clean

     7. At least once a week, the oil cylinder needs to be lubricated (stator oil) and the mechanical oil pipe system must be supplied with a manual pressure pump. The linear guide rail and ball screw must be fully lubricated, and the running in lubrication must be adjusted from small width to large width to prevent memory damage to the guide rail and screw caused by prolonged grinding of glass

     8. For lubrication of the conveyor belt, please use light engine oil and spray a little under the Timing belt with a spray gun

     9. Add lubrication to the motor slide once a week
Article by: Glass bilateral machine http://aoama.cn Provided by Foshan Yuanbo Intelligent Technology Co., Ltd., this article does not represent the views of this website


Professional manufacturing of high speed intelligent double edging machine production lines
?2000 FOSHAN YUANBO INTELLIGENTT TECHNOLOGY CO., LTD. All Rights Reserved | Some of the images on this website are sourced from the internet. If there are copyright issues, please inform us to delete them according to the contact information published on the website.
top